Swing Arms
This is a stock replacement for the 09-present FL models. These swing arms feature our fully machined front bearing blocks to ensure a proper bearing fitment and alignment. They are also machined with bearing stops to keep the bearing secure in the swing arm. The rear axle supports are machined in house with built in shock mounts for added strength and proper shock alignment. The axle blocks are designed to secure the axle nut, not allowing it to turn while being torqued on the other side. These swing arms were designed to use a 12” stock shock and not change your ride height and provisions to lower your bike 1” by moving them back. This arm will allow you to run your stock belt with the confidence that all adjustments will stay secure where you set them. This arm has the capability of running a longer belt to accommodate a smaller pully if gear ratio change is needed. It will also accommodate our chain conversion kits and allow you to run a chain drive and a 2” over length on your bike (3” is capable without bottom light under fender).